Our standalone harnesses aren’t just for MK1 Chassis. You can install VW motors in vitually any car. Honda, Toyota, Lawn mowers, Ferrari, Rabbit ,MK2 SCIROCCO AND MORE!
Fabrication of course is always required for the engine mounts but the wiring is simple.
These are some of harnesses we make, if you don’t see it listed just send us an email! firstname.lastname@example.org
– Using the factory twist lock connector the harness plugs into and the rest is cake walk!
– Harness will work on any make or model as long as used on OBD1 / OBD2 VR6 motors
– OEM friction tape wrapped (optional)
– OEM connectors
– OBD 2 Diagnostic Connector Wired in (OBD 2 only)
We stock most harnesses but if you have your donor motor harness than that saves you money!
Ship us your good un-cut harness.
“average turn around time is 1-2 weeks once we receive your core harness”
EUROWISE CUSTOM HARNESS FORM LINK BELOW:
( PLEASE FILL OUT AND PRINT AND PUT INTO YOUR CORE MAILING BOX. IF YOU DO NOT HAVE A CORE TO SEND PLEASE FILL OUT AND EMAIL TO US AFTER PAYING FOR YOUR HARNESS ONLINE )
EUROWISE CUSTOM HARNESS FORM
Q: I have purchased your mk1 VR6 swap an have successfully installed a 97 VR6 in my 82 caddy. Now comes the difficult part, the wiring. I know you offer a plug and play wiring harness and I want one. I have a few questions though, Do you first need my harness to build it or do you have harnesses in stock?
A: A core will need to be mailed into the shop to have the harness modification completed. Unfortunately these harnesses have become hard to come by, and we do not have any modified harnesses in stock. *** DO NOT ORDER IF YOU DO NOT HAVE A CORE TO SUPPLY. ***
Q: All of the secondary air components have been removed, does the harness also have the wiring removed for these components?
A: Yes the harness is for a deleted emissions system
Q: I am using all vdo gauges does your harness supply me with a tach signal and speed signal?
A: Speed signal you will have to obtain the correct cable for the transmission which is separate from the engine harness. The tach signal is a little more tricky. It requires a converter to get the tach signal from a 4 cyl – 6 cylinder to work properly. We don’t have a solution currently for this
Before using harness ensure motor has a quality ground and that starter operation is good. If a bad engine ground is present the harness will act as a ground and MELT the chassis/engine ground circuit in the harness. Before putting any of the harness in simply “crank” the engine and make sure it cranks “normal”
When hooking both harness battery leads up be sure to fuse the leads AT the BATTERY with 30 amp fuses for safety of harness and car in case of chaffing or shorts.
At Eurowise we specialize in Audi service, BMW service, Mercedes Benz service, Porsche service, Ferrari service, Maserati service, Lamborghini service, and Volkswagen service. We also specialize in Performance fabrication, which includes welding, high performance race car prep. All automotive repairs done at one of our three locations using state of the art diagnostic, programming, and repair equipment. We spare no expense when it comes to using the right tools to properly repair your car. Eurowise has factory trained technicians along with a very knowledgeable customer care staff with over 60 years of combined experience in the auto repair, racing and fabrication industry.
If you are interested in having your vehicle serviced please contact us at..
440 Springbrook Rd
Charlotte, NC 28217
704-559-8100 ext. 3
441 springbrook rd
Charlotte NC, 28217