2011 Mercedes Benz E350 Coolant Leak, Frayed Drive Belt (Mercedes Repair)

Customer brought us his 2011 Mercedes E350 in for coolant loss. After pressure testing cooling system we found water pump was the source of the problem.

While replacing water pump noticed engine drive belt was fraying due to worn drive belt tensioner.

While replacing water pump we also recommend lower radiator hose as this is a problematic issue on these models.

If you’re experiencing coolant loss in your Mercedes Benz, don’t wait until it leaves you stranded or worse possible engine damage. Due to the age of this vehicle it would never hurt to replace water pump as preventive maintenance so you have piece of mind. If you’re experiencing this issue with your Mercedes then please give us a call to schedule an appointment -> 704 559 8100

eurowise EW Service

2006 Mercedes Benz ML350 Balance Shaft Failure

mercedes benz balance shaft failure

Customer brought us his 2006 Mercedes-Benz ML350 with a check engine light followed by engine noise. After our diagnostics we found balance shaft has failed.

This is a very common issue with the Mercedes M272 and M273 motors up to 2008.

Here you can see that the balance shaft gears are completely gone! We don’t know how this car was still running with no gears. But luckily customer made it just in time before catastrophic engine damage…

If your hearing strange noises coming from your Mercedes-Benz, don’t wait until it’s too late! Give us a call to schedule an appointment – 704 559 8100

eurowise EW Service

2013 Audi Allroad leaking CV boot repair

Customer brought us his 2013 Audi Allroad for a leaking outer CV boot.

Failure to repair a leaking CV boot can result in damaging entire axle assembly. As you may know NEW OEM axles are not cheap. Aftermarket axles are available but not the quality of an OEM axle. So don’t wait until it’s too late, call and schedule an appointment today – 704 559 8100

We only use Genuine OEM parts!

JT installing NEW CV boot…

eurowise EW Service

2006 Audi A8 Camshaft Adjuster Failure

Customer brought us his 2006 Audi A8 with a check engine light followed by loud grinding noise coming from engine. After our diagnostics we found bank 1 cylinder camshaft adjuster failing.

New adjuster installed with new timing chain…

As you can see here guide on adjuster is completely gone and timing chain wearing into metal.

If you hear odd noises coming from your engine don’t wait as damage may be happening. Give us a call today to schedule an appointment – 704 559 8100.

eurowise EW Service

BMW – 5 Series Faulty Eccentric Shaft Sensor

Client brought us his 2011 BMW 528 for throttle delay/hesitation followed by a check engine light.

We found faulty eccentric shaft sensor and bad #1 cylinder ignition coil. After repairs no more check engine light or delay.

This is quite a common issue, most of the time sensor gets contaminated with oil and fails. What you would notice is sluggish driving, hesitation, poor performance, jerky shifts from an automatic, and other drivability issues.

If your experiencing this issue on your BMW don’t wait as more damage may occur. Call us today and schedule an appointment. 704-559-8100

eurowise EW Service